The use of dedicated accessories significantly reduces the risk of damage when assembling the gaskets: gaskets that are not mounted correctly increase the number of interventions to replace them and therefore the costs.
Installing a groove gasket is a simple operation in itself but requires a certain amount of care so as not to lose the function of the gasket.
The articles in this category help you comply with the instructions for correct assembly.
ADHESIVE FOR ROPE OR NBR SICOMET 8300 20 g : this rapidly curing cyanoacranyl glue is for gluing our NBR ropes. It can be used at temperatures up to +80°C and for short periods up to +100°C
SHEARS GMBH2 0024023 - GMBH : These shears, thanks to the very hard and sharp trapezoidal blade, are particularly suitable for use with softer materials, such as rubber and PTFE tapes. Available with safety stop at 45° and 90°, or without safety stop like classic anvil shears. Quick blade replacement.
REPLACEMENT BLADES FOR SHEARS GMBH 6-11-916
ULTRASHARP SHEARS 4.0 98665000016783 =
Ultrasharp 60 is the shear suitable for
cutting guide tape in materials
details such as phenolic resins and
PTFE, with 60 degree cutting angle.
PTFE 40/250 ENLARGE CONE : This item is suitable for the assembly of PTFE piston seal gaskets, it expands the seal and facilitates assembly (see the video of the article).
REPLACEMENT FOR PTFE ENLARGEMENT = replacement of the cone
PTFE CHOKE CALIPER 5.0 NEW 50mm/360mm = This pliers is used to bring PTFE piston seals (GER) to size, it can operate with seals with external diameters from 1.97" (50mm) to 14.17" (360mm).
The belt is made of stainless steel and adapts to the external diameter of the gasket, the pliers are also supplied with a plastic triangle to avoid damage when tightening the belt on the piston.
PTFE GREASE 100 ML
PTFE GREASE 500 GR : these two PTFE-based greases are indicated for correct assembly, so as not to compromise the mechanical seal function, to improve the seal, to avoid damaging the sealing profile.
GLUE OR CALIBRATED : this article is used to block the O-ring rope with a diameter ranging from 0.1"/2.5mm up to 0.79"/20mm, to facilitate the joining of the same, gluing with the most suitable product for the mix that you want to apply.
CALIBRATED CORD CUTTER : this item allows accurate and clear cuts on the corad o-ring that will be glued.
It is suitable for diameters ranging from 2.62mm to 14mm.
It works with toric section profiles of various elastomers, furthermore the blades are interchangeable.
Mounting are interchangeable with:
